Lenovo ThinkCentre M57 Hardware Maintenance Manual - Page 69
Signal/Loopback
View all Lenovo ThinkCentre M57 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Diagnostic Error Code FRU/Action 011-000-XXX Serial port Interface Test Passed No action 011-001-XXX Serial port Presence 1. Remove external serial device, if present 2. Run setup, enable port 3. System board 011-002-XXX 011-003-XXX Serial port Timeout/Parity error System board 011-013-XXX 011-014-XXX Serial port Control Signal/Loopback test failure System board 011-015-XXX Serial port External Loopback failure 1. Wrap plug 2. System board 011-027-XXX Serial port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 442 3. System board 011-03X-XXX 011-04X-XXX Serial port failure System board 011-195-XXX Serial port Test aborted by user Information only Re-start the test, if necessary 011-196-XXX 1. Press F3 to review the log file Serial port test halt, error threshold exceeded 2. Re-start the test to reset the log file 011-197-XXX Serial port test warning 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 011-198-XXX Serial port test aborted 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Flash the system and re-test. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 442 3. Go to "Undetermined problems" on page 82 Chapter 7. Symptom-to-FRU Index 63