Lenovo ThinkPad 600E TP 600E On-line User's Guide that was provided with the s - Page 136
Disabling the Unnecessary CD-ROM Device Drivers for Windows 95, DOS and Windows
View all Lenovo ThinkPad 600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
2 Insert the ThinkPad Modem for Windows 95/98/NT Disk 1 into the diskette drive. 3 Click on Start, and then Run.... 4 Type A:\SETUP and press Enter. | If the previous version of the driver is installed, the ThinkPad | Modem setup program displays a message. Remove the | previous version of the driver by using the uninstall tool | provided in the ThinkPad DSP program. If the previous version | of the driver is not installed, a message saying that Windows | has found an unknown device appears. Insert the ThinkPad | Modem for Windows 95/98/NT diskette into the diskette drive. Follow the instructions on the screen. Note: You need to set the dialing properties when using the ThinkPad Modem functions. Click on Control Panel, Modems, and then the Dialing Properties button. For IRQ-sharing information, refer to Sharing an IRQ between ThinkPad Modem Devices. Disabling the Unnecessary CD-ROM Device Drivers for Windows 95 This section describes how to disable the unnecessary DOS and Windows CD-ROM device drivers. If you installed Windows 95 on a blank hard disk drive without DOS and Windows, Windows 95 has automatically installed a generic ATAPI CD-ROM device driver for your ThinkPad's CD-ROM drive. You do not need to do the following procedure. If you installed Windows 95 in a computer on which DOS and Windows had been already installed, you need to disable the DOS and Windows CD-ROM device drivers to use the correct Windows 95 generic ATAPI CD-ROM device driver. To disable the DOS and Windows CD-ROM device drivers: 1 Start Windows 95 and go to the MS-DOS command prompt. 128 IBM ThinkPad 600E Online Book