Lenovo ThinkPad Edge L330 Hardware Maintenance Manual - ThinkPad Edge L330 - Page 40

Symptom-to-FRU index, Numeric error codes

Get Lenovo ThinkPad Edge L330 PDF manuals and user guides View all Lenovo ThinkPad Edge L330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

When the power is turned on, the computer returns from hibernation mode and resumes operation. The hibernation file in the boot record on the hard disk drive is read, and system status is restored from the hard disk drive. Symptom-to-FRU index This section contains following information: • "Numeric error codes" on page 34 • "Error messages" on page 35 • "No-beep symptoms" on page 35 • "LCD-related symptoms" on page 35 • "Intermittent problems" on page 36 • "Undetermined problems" on page 36 The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most likely cause is listed first, in boldface type. Note: Do the FRU replacement or other actions in the sequence shown in the column headed "FRU or action, in sequence." If replacing a FRU does not solve the problem, put the original part back in the computer. Do not replace a nondefective FRU. This index can also help you determine, during regular servicing, what FRUs are likely to need to be replaced next. A numeric error is displayed for each error detected in POST or system operation. In the displays, n can be any number. If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not described there, go to "Intermittent problems" on page 36. Note: For a device not supported by diagnostic codes in the ThinkPad notebooks, see the manual for that device. Numeric error codes Table 1. Numeric error codes Symptom or error (beeps, if any) FRU or action, in sequence 0187 System board. EAIA data access error - The access to EEPROM is failed. (two short beeps) 0189 Invalid RFID configuration information area - The EEPROM checksum is not correct. (two short beeps) System board. 0190 Critical low-battery error (two short beeps) 1. Charge the battery pack. 2. Battery pack. 0191 System Security - Invalid Remote Change requested. 1. Run the ThinkPad Setup program, and then save current setting by pressing Fn+F10. 2. System board. 0251 System CMOS checksum bad - Default configuration used. (two short beeps) 1. Charge the backup battery for more than 8 hours by connecting the ac power adapter. 2. Replace the backup battery and run the ThinkPad Setup program to reset the time and date. 34 Hardware Maintenance Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
When the power is turned on, the computer returns from hibernation mode and resumes operation. The
hibernation file in the boot record on the hard disk drive is read, and system status is restored from the
hard disk drive.
Symptom-to-FRU index
This section contains following information:
•
“Numeric error codes” on page 34
•
“Error messages” on page 35
•
“No-beep symptoms” on page 35
•
“LCD-related symptoms” on page 35
•
“Intermittent problems” on page 36
•
“Undetermined problems” on page 36
The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most
likely cause is listed first, in boldface type.
Note:
Do the FRU replacement or other actions in the sequence shown in the column headed “FRU or
action, in sequence.” If replacing a FRU does not solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular servicing, what FRUs are likely to need to be
replaced next.
A numeric error is displayed for each error detected in POST or system operation. In the displays,
n
can
be any number.
If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not
described there, go to “Intermittent problems” on page 36.
Note:
For a device not supported by diagnostic codes in the ThinkPad notebooks, see the manual for
that device.
Numeric error codes
Table 1. Numeric error codes
Symptom or error (beeps, if any)
FRU or action, in sequence
0187
EAIA data access error - The access to EEPROM is failed.
(two short beeps)
System board.
0189
Invalid RFID configuration information area - The EEPROM
checksum is not correct.
(two short beeps)
System board.
0190
Critical low-battery error
(two short beeps)
1.
Charge the battery pack.
2. Battery pack.
0191
System Security - Invalid Remote Change requested.
1.
Run the ThinkPad Setup program, and then save
current setting by pressing Fn+F10.
2. System board.
0251
System CMOS checksum bad - Default configuration
used.
(two short beeps)
1.
Charge the backup battery for more than 8 hours
by connecting the ac power adapter.
2. Replace the backup battery and run the ThinkPad
Setup program to reset the time and date.
34
Hardware Maintenance Manual