Lexmark 2030 Color Jetprinter Service Manual - Page 25

Access Cover Removal, Base Assembly Removal, Carrier Belt Removal, Repair Information 4-3

Get Lexmark 2030 Color Jetprinter PDF manuals and user guides View all Lexmark 2030 Color Jetprinter manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

4091-001 Access Cover Removal 1. Open the access cover. 2. Push the mounting tabs toward the center of the machine. 3. Remove the access cover. Base Assembly Removal 1. Remove the front cover. 2. Remove the rear cover. 3. Remove the sheet feeder. 4. Disconnect the DC/DC converter connector at the system board. 5. Remove the two screws that secure the carrier frame to the base assembly. 6. Remove the screw that secures the DC/DC Converter frame to the carrier frame. 7. Press down on the left side clip and slide the DC/DC converter out of the base. 8. Unlatch the carrier frame from the base assembly and lift it off the base. 9. Slide the machine off the base assembly. Carrier Belt Removal 1. Remove the front cover. 2. Remove the retainer spring from the left side of the carrier rod. 3. Remove the screw from the right side of the carrier rod. 4. Slide the carrier rod to the left, out of the machine. 5. Remove the carrier belt from the rear of the carrier. 6. Remove the carrier belt from the carrier transport motor pulley. 7. Remove the carrier belt. Repair Information 4-3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
Repair Information 4-3
4091-001
Access Cover Removal
1. Open the access cover.
2. Push the mounting tabs toward the center of the machine.
3. Remove the access cover.
Base Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Disconnect the DC/DC converter connector at the system
board.
5. Remove the two screws that secure the carrier frame to the
base assembly.
6. Remove the screw that secures the DC/DC Converter frame to
the carrier frame.
7. Press down on the left side clip and slide the DC/DC converter
out of the base.
8. Unlatch the carrier frame from the base assembly and lift it off
the base.
9. Slide the machine off the base assembly.
Carrier Belt Removal
1. Remove the front cover.
2. Remove the retainer spring from the left side of the carrier rod.
3. Remove the screw from the right side of the carrier rod.
4. Slide the carrier rod to the left, out of the machine.
5. Remove the carrier belt from the rear of the carrier.
6. Remove the carrier belt from the carrier transport motor pulley.
7. Remove the carrier belt.