Lexmark C510 Setup Guide - Page 53
Verifying the IPsettings, Configuring for PullPrinting, Set IP Gateway, Ready, ping xxx.xxx.xxx.xxx
View all Lexmark C510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Verifying the IP settings Note: On Windows computers, click Start Run. Configuring for Pull Printing 8 Repeat step 6 to set the IP Netmask. 9 Press Menu until you see Set IP Gateway, and then press Select. 10 Repeat step 6 to set the IP Gateway. 11 When you are finished, press Go to return the printer to the Ready state. 12 Go on to "Verifying the IP settings" on page 48. 1 Print another network setup page. Look under the "TCP/IP" heading and make sure the IP address, netmask, and gateway are what you expected. See "Printing a network setup page" on page 45 if you need help. 2 Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping followed by the new printer IP address (for example, 192.168.0.11): ping xxx.xxx.xxx.xxx If the printer is active on the network, you should receive a reply. If your printer has an optional ImageQuick firmware card installed, you can configure for Pull Printing once an IP address has been assigned to the printer. For detailed configuration instructions, refer to the CD that shipped with the ImageQuick firmware card. Configure for TCP/IP 48