Lexmark Dot Matrix Quick Reference - Page 15
Top-Of-Form, Setting Top-Of-Form for continuous form paper, in push mode
View all Lexmark Dot Matrix manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Top-Of-Form Setting Top-Of-Form for continuous form paper in push mode Top-Of-Form can range from minus 1 inch to plus 14 inches from the top of continuous form paper. Note: Use this method to also setTop-Of-Form for continuous forms loaded in the optional Tractor 2 Feeder. 1 Clear the paper path. If the Paper Out light is Off, tear off excess forms and press Load/Unload. Press FormFeed to clear a cut sheet. 2 Move the paper select lever to continuous forms . 3 Load continuous form paper on the push tractor feed pins (or Tractor 2 feed pins if you are using the optionalTractor 2 Feeder). 4 Remove the ribbon access cover. 5 Press Load/Unload. The Paper Out light goes Off. 15
15
Top-Of-Form
Setting Top-Of-Form for continuous form paper
in push mode
Top-Of-Form can range from minus 1 inch to plus 14 inches from the top of
continuous form paper.
Note:
Use this method to also setTop-Of-Form for continuous
forms loaded in the optional Tractor 2 Feeder.
1
Clear the paper path.
If the Paper Out light is
Off
, tear off excess forms and press
Load/Unload
.
Press
FormFeed
to clear a cut sheet.
2
Move the paper select lever to continuous forms
.
3
Load continuous form paper on the push tractor feed pins (or Tractor 2
feed pins if you are using the optionalTractor 2 Feeder).
4
Remove the ribbon access cover.
5
Press
Load/Unload
. The Paper Out light goes
Off
.