LiftMaster 98032 LiftMaster Model 98032 Logic Board Instruction Sheet - Englis - Page 4
Programming
View all LiftMaster 98032 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
PROGRAMMING REMOTE CONTROL Your remote control has been programmed at the factory to operate with your garage door opener. If the remote does not work or you would like to program additional devices, follow the programming steps below. Up to 40 Security+ 2.0® remote controls can be programmed to the garage door opener. Older LiftMaster remote controls are NOT compatible. Programming can be done through the door control or the learn button on the garage door opener. To program additional accessories refer to the instructions provided with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink®, you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional information. To add, reprogram, or change a 893LM remote control/877LM 1. keyless entry pin using the door control 2. Press to continue 1. Press the navigation button below "MENU" to view the Features menu. 2. Use the navigation buttons to scroll to "PROGRAM". 3. Select "REMOTE" or "KEYPAD" to program from the program menu. 4. Remote Control: Press the button on the remote control that you wish to operate your garage door. 5. Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. Repeat the steps above for programming additional remote controls or keyless entry devices. If programming is unsuccessful, program the remote using the learn button. 1. 2. 3. Press 3. Program a 893MAX remote control using the learn button on the garage door opener 1. Press and hold the program button on the remote control until the LED on the front of the remote control turns on. 2. Press and release the remote control button you wish to use and then press any other button to exit programming. 3. Press and release the Learn button on the garage door opener. The Learn LED will light. Within 30 seconds... 4. Press the remote control button programmed in step 2 until the garage door opener light flashes or two clicks are heard. To program other types of remote controls or keyless entries see the instructions included with the device or visit LiftMaster.com. Visor Clip Add MyQ serial number to MyQ App To program the Wi-Fi garage door opener to your network, refer to your owner's manual. 114-5922-000 © 2023, LiftMaster All Rights Reserved Tous droits réservés Todos los derechos reservados 4 to continue LEARN Button LEARN LED 4. OR PIN 4. "click""click" LiftMaster 300 Windsor Drive Oak Brook, IL 60523 LiftMaster.com