LiftMaster CSW24V CSW24V Installation Manual - Page 18
Weld The Operator Arm, Secure The Operator Arm To The Output Shaft - gear box
View all LiftMaster CSW24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
INSTALLATION INSTALLATION CONTINUED... WELD THE OPERATOR ARM Once the operator arm measurements are verified: 1 1 Weld the gate bracket to the gate. 2 Weld the short arm section. 3 Weld the long arm section. 4 Remove the set screws from the arm. NOTE: Completely weld around the outer tubing and bracket. SECURE THE OPERATOR ARM TO THE OUTPUT SHAFT 1 Adjust the nuts on the operator arm so the operator arm fits snug on the output shaft yet still allows enough room to swivel (the handle must be in a 90° position). 2 Tighten the handle by pushing it down. Test to make sure the operator arm does not slip on the output shaft. INSTALLATION CONTINUED... 3 2 1 2 REMOVE THE PINS FROM THE VENT PLUGS 1 Remove the pin from the vent plug on both the top and bottom gear boxes. Top Gear Box Bottom Gear Box 16 Pin Vent Plug