LiftMaster Dial Code Dial Code LC and VF Series Manual - Page 26
Transmitter/card Programming, Transm/card#1
View all LiftMaster Dial Code manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
TRANSMITTER/CARD PROGRAMMING 6 STEP To complete entry, press the key to return to the program selection screen. To program RF devices ( i.e. transmitters/cards etc.) continue on to Step 7. NOTE: To enable the transmitter/card programming feature, you must insert the communicator card in the "backup" slot before you turn on unit. (refer to "Memory Card Installation" section) 7 STEP Use keys to view and program up to 10 transmitter or card codes associated to the directory code. To program a transmitter or card code you may enter the code manually using the keypad or you may scan the transmitter/card code. 8 STEP To scan a card code, press and release the S key and activate the card as shown in fig a. To scan a transmitter code, press and release the S key and activate the transmitter as shown in fig b. 005 TRANSM/CARD#1 S) SCAN 005 TRANSM/CARD#2 S) SCAN •••• 005 TRANSM/CARD#10 S) SCAN Touch the card to the card reader to activate remote device Model ECR485B (fig a.) 9 STEP 1 2 3 4 5 6 7 8 9 ERASE EX T PROGRAM ENTER HELP Q W E R T Y 0 U I O P SHIFT A S D F G H J K L SPACE BAR Z X C V B N M ' BACK SPACE (fig b.) Processor STAND-ALONE RECEIVER Model ERRB485 Press button on transmitter to activate remote device Repeat steps 7 and 8 for up to ten devices per directory code. After the last device has been programmed, press or key to return to the program selection screen. NOTE: The time zones and restrictions associated with transmitter/card codes can only be programmed remotely using the EMS modem software. LC/VF Page 25