LiftMaster Dial Code Dial Code LC Series Manual - Page 21

TRANSMITTER/CARD PROGRAMMING 6 STEP To complete entry, press the key to return to the program selection screen. To program RF devices ( i.e. transmitters/cards etc.) continue on to Step 7. NOTE: To enable the transmitter/card programming feature, you must insert the communicator card in the "backup" slot before you turn on unit. (refer to memory card installation section of manual) 7 STEP Use keys to view and program up to 10 transmitter or card codes associated to the directory code. To program a transmitter or card code, you may enter the code manually using the keypad or you may scan the transmitter/card code. 005 TRANSM/CARD#1 S) SCAN 005 TRANSM/CARD#2 S) SCAN •••• 005 TRANSM/CARD#10 S) SCAN 8 STEP To scan a card code, press the "S" key and activate the card as shown in fig a. To scan a transmitter code, press the "S" key and activate the transmitter as shown in fig b. ECR-485W (fig a.) Touch the card to the card reader to activate remote device Processor Stand Alone Reciever Model ERRB 485 (fig b.) Press button on transmitter to activate remote device. 9 STEP Repeat steps 7 and 8 for up to ten devices per directory code. After the last device has been programmed, press or key to return to the program selection screen. NOTE: The time zones and restrictions associated with transmitter/card codes can only be programmed remotely using the EMS modem software. PAGE 20