Lowrance Auto-Standby button Metal Addendum software release v20.2 for Zeus2 G - Page 13

A B When true motion is selected, the true motion reset option is available from the menu. This allows for manually resetting the radar image and vessel symbol to its starting position. Ú Note: True motion is only available when the PPI is in either north up or course up orientation mode. To set to true motion in the MFD, select the Position option in the More menu and then select the True motion option. Radar symbology Use this menu option to collectively turn on/off radar symbology which are selected to show in the Radar Settings panel (refer to "Radar settings" on page 14). Target trails A target trail indicates the target movement by leaving an afterglow, gradually reducing the intensity over time. Target trails show where a target used to be, and the function is useful for quickly assessing the movement of targets relative to your own vessel. You can set the length of the trails. The length represents the time it takes for the trails to fade out. You can also turn OFF target trails. Clear trails The clear trails option clears target trails from your radar panel temporarily. The trails start to build up again unless you switch the function off. EBL/VRM markers The electronic bearing line (EBL) and variable range marker (VRM) allows quick measurements of range and bearing to vessels and landmasses within radar range. Two different EBL/VRMs can be placed on the radar image. The EBL/VRMs are by default positioned from the center of the vessel. It is, however, possible to offset the reference point to any selected position on the radar image. Defining an EBL/VRM marker 1. Ensure that the cursor is not active. 2. Activate the More menu, select EBL/VRM, and then select EBL/VRM 1 or EBL/VRM 2. The EBL/VRM is now positioned on the radar image. 3. Select the adjustment option from the menu if you need to reposition the marker. 4. Adjust the marker by dragging it into position. 5. Save your settings. ADDENDUM | Zeus Series 13