Lowrance Broadband 4G Radar Installation Guide - Page 12
Mounting the scanner
View all Lowrance Broadband 4G Radar manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Mounting the scanner Use the supplied mounting template and tape it securely to the chosen location. Before drilling, check that: • you have oriented the mounting template correctly so that the front of the scanner unit will face the front of the vessel • the thickness of chosen location is not more than 18 mm (0.7") thick. If the location is thicker, longer bolts than those supplied will be required • the four bolts supplied are M8 x 30 mm. If you need to use longer bolts make sure they are marine grade stainless steel and allow for minimum of 8 mm (0.3") and maximum of 18 mm (0.7") of thread contact 1. Use a 9.5 mm (3/8") drill bit to drill the four holes where shown on the mounting template 2. Remove the mounting template 3. Connect the scanner interconnection cable (see "Connect interconnection cable to the scanner" on page 11 ) 4. Route the connection cable through the cable retention channel 6. Position the scanner carefully over the bolt holes so that they are aligned 7. Place a lock washer and a plain washer onto each bolt, as shown 8. Insert bolt into drill hole and locate into scanners threaded mounting holes and tighten securely Note: The torque settings for the mounting bolts are 12 Nm - 18 Nm (8.9 lb ft - 13.3 lb ft) 10 | Installation | Broadband 3G/4G™ Radar Installation Guide