Lowrance StructureScan HD Module Installation Manual - Page 7
Installation and Wiring - transducer mounting
View all Lowrance StructureScan HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2 Installation and Wiring The StructureScan HD black box module connects between the transducer and display unit, or via a network switch. Before installing the module, consider location and cable runs necessary to connect the module to the display unit and power source. Do not run the transducer cabling near the module DC power cables or any VHF antenna coax or power cables for the VHF. The module conforms to the appropriate Electromagnetic Compatibility (EMC) standards; but proper installation is required to get the best use and performance from this product. Selecting mounting location When installing the module certain factors that could affect its operation should be considered. Ensure you have as much separation as possible between different electrical equipment, (see diagram). Sunlight X Salt spray Physical damage X Electromagnetic interference Gasoline fumes Vibration Heat RADAR Compass 1.5 m (5 ft) Min Radio Antenna and cabling or AIS Transmitter 2.0 m (6.5 ft) Min 1.8 m (6 ft) Min Make sure the transducer cable is long enough to connect to the module. If not, an extension cable is available (only one extension is recommended for optimal performance). For transducer cable length see Spare parts and accessories, page 12. Installation and Wiring | StructureScan HD Installation | 7