Mackie CR1604 Modifications - Page 14

When the Aux 1/2 Pre Switch is, Do not strip off any more insulation than

Get Mackie CR1604 PDF manuals and user guides View all Mackie CR1604 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

B. When the Aux 1/2 Pre Switch is not engaged, Aux Send 1 and 2 function normally, as post fader channel sends. All that said, here's the mod. See Figure above. This modification takes place on each channel strip in the area under the AUX 3/4 Mix-V Source switch and also under and near the AUX 1/2 PRE switch. 1. Remove power cord. 2. Cut two (2) traces at point (A). Note: The wire used in the next three steps should be 24-28 gauge insulated jumper wire. Do not strip off any more insulation than is absolutely necessary. 3. Add a 1-1/2" jumper (B), connected at points K and L. 4. Add a 2-1/4" jumper (D), connected at points P and Q. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
14
B.
When the Aux 1/2 Pre Switch is
not
engaged, Aux Send 1 and 2 function nor-
mally, as post fader channel sends.
All that said, here’s the mod.
See Figure above. This modification takes
place on each channel strip in the area
under the AUX 3/4 Mix-V Source switch
and also under and near the AUX 1/2
PRE switch.
1.
Remove power cord.
2.
Cut two (2) traces at point (A).
Note: The wire used in the next three
steps should be 24-28 gauge insulated
jumper wire.
Do not strip off any more insulation than
is absolutely necessary.
3.
Add a 1-1/2” jumper (B), connected at
points K and L.
4.
Add a 2-1/4” jumper (D), connected at
points P and Q.