Magnavox MDR700 User manual, English (US) - Page 27

Troubleshooting - repair

Page 27 highlights

English Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Magnavox for help. Problem Disc cannot play Solution ✔ Make sure a disc is loaded. ✔ Make sure a disc is loaded with the label side up. ✔ Disc dirty or damaged. Clean the disc. ✔ Make sure the region code of the player is the same as that of the DVD disc loaded. ✔ Moisture has condensed in the player. Remove the disc and leave the player power-on until the moisture evaporates. No sound ✔ Check whether the set is connected securely. ✔ Make sure the set is not in the MUTE mode. If it is, press MUTE to turn on the speaker. ✔ Check whether the volume on the set has been set to the lowest level. If it has, turn up the volume. ✔ Disc dirty/damaged. Clean or replace the disc. No picture, unsteady picture or incorrect picture position ✔ Make sure the video type of the AV signal source is NTSC. ✔ Check whether the set is connected securely. ✔ Disc dirty/damaged. Clean or replace the disc. Failure in playing a disc continuously or repeated playback of a disc ✔ Make sure the player is not in the A-B repeat status. If it is, press A-B to cancel A-B repeat. ✔ Disc dirty/damaged. Clean or replace the disc. Remote control does not work ✔ Remove obstacles between the remote control and the player, and point directly instead of at a wide angle at the infrared sensor on the player. ✔ Make sure the battery has been inserted properly (check polarity). ✔ Battery maybe exhausted. Replace the battery with a new one. 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

27
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty.
Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Magnavox for help.
Problem
Solution
Troubleshooting
Disc cannot play
No sound
No picture, unsteady picture or incorrect
picture position
Failure in playing a disc continuously or
repeated playback of a disc
Remote control does not work
Make sure a disc is loaded.
Make sure a disc is loaded with the label side up.
Disc dirty or damaged. Clean the disc.
Make sure the region code of the player is the
same as that of the DVD disc loaded.
Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
Check whether the set is connected securely.
Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
Disc dirty/damaged. Clean or replace the disc.
Make sure the video type of the AV signal source
is NTSC.
Check whether the set is connected securely.
Disc dirty/damaged. Clean or replace the disc.
Make sure the player is not in the A-B repeat
status. If it is, press A-B to cancel A-B repeat.
Disc dirty/damaged. Clean or replace the disc.
Remove obstacles between the remote control
and the player, and point directly instead of at a
wide angle at the infrared sensor on the player.
Make sure the battery has been inserted
properly (check polarity).
Battery maybe exhausted. Replace the battery
with a new one.