Makita BTP140Z Owners Manual - Page 7
Assembly, Operation
View all Makita BTP140Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or socket bit 004521 2. To install the bit, pull the sleeve in the direction of the arrow and insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. Then release the sleeve to secure the bit. 004347 1. Bit 2. Bit-piece 3. Sleeve 1 2 3 Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit. For European and North & South American countries, Australia and New Zealand 006348 A=12mm Use only these type of bit. Follow the B=9mm procedure (1). (Note) Bit-piece is not necessary. For other countries 006349 To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. Hook (Accessory) 3 006251 1. Hook 2. Screw 2 3. Groove A=17mm To install these types of bits, follow the procedure (1). 1 B=14mm (Note) Makita bits are these types. A=12mm B=9mm To install these types of bits, follow the procedure (2). (Note) Bit-piece is necessary for installing the bit. 1. To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit. 001267 1. Bit 2. Sleeve CAUTION: • When installing the hook, tighten the screw firmly. Failure to do so may cause the breakage of the tool or personal injury. The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. OPERATION 1 2 CAUTION: • Always insert the battery cartridge all the way until it locks in place. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. 7