Marantz RC1400 RC1400 User Manual - Page 42
RX-S direct button
View all Marantz RC1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
ENGLISH 1 Place the receiver sensor of the receiving remote control (top) so that it is facing the transmitter of the transmitting remote control (top) at a distance of about 5 cm (2 inches). 2 Hold down the M button r of the transmitting remote control for three seconds or more. The menu is displayed. 3 Press the > button y to display the fourth page CLONE menu. 4 Press the D3 (TX) direct button t. The transmitting side is now ready. 5 Hold down the M button r of the receiving remote control for three seconds or more. 6 Press the > button y to display the fourth page CLONE menu. 7 Press the D2 (RX-S) direct button t. 8 Press the source button !4 to be copied. The receiving side is now ready. The name of the source which was pressed is displayed on the LCD. • Each time the source button is pressed, the name is displayed on the LCD. 9 Press the OK cursor button @0 on the receiving remote control. 10 Press the OK cursor button @0 on the transmitting remote control. When copying is started, the bar indicators on both LCDs start to move from the left to the right. • When the copying operation is completed, TX OK is displayed on the LCD of the transmitting remote control, and RX OK is displayed on the LCD of the receiving remote control. • Do not touch either of the remote controls during the copying operation. Doing so could cause copying to fail. • If the copying fails in the middle of the copying process, ERROR is displayed on the remote control. Check and perform steps 1 to 7 again. 11 Once copying is completed, press the M button r on both remote controls. 3 40 Page 40 03.10.6, 4:19 PM "EPCF1BHF.BLFS+11$