Marantz RC3001 User Guide - Page 11

ENGLISH RX3001 x n ON OFF 1 2 3 4 ID 12 m , . 123456 b ⁄0 c z RX3001 v z DC jack This jack connects to the supplied AC adapter. x Antenna This is a rod antenna for receiving RF signals. c IR blasters (upper direction) These transmit IR signals. The Wizz.it 3 editor software can be used to turn transmission of the IR signals on and off. v IR blasters (front direction) These transmit IR signals. The Wizz.it 3 editor software can be used to turn the IR signal transmissions on and off. b IR output jack This jack connects the supplied IR emitter cable. n Key holes These holes are used to mount the remote controller to a wall. For the mounting procedure, see lMounting the RX3001 to a Wallz on page 8. m IR output level switches These DIP switches set the IR transmission level from IR output jacks 1 to 3 and IR output jacks 4 to 6. , Group ID selector switch This switch sets the IR output group ID for IR output jacks 1 to 3 and IR output jacks 4 to 6. . CH selector switch This switch sets the reception channel. Set to the same channel as the RC3001. Note: The CH selector has eight setting positions, but only four channel positions can be set. ⁄0 Power indicator The red LED turns on when the AC adapter is connected. The red LED flashes when receiving signals. 6