Marantz RC3001 User Guide - Page 17

ENGLISH SETUP SETTING THE IR OUTPUT LEVEL The DIP switches at the bottom of the RX3001 can be used to set the IR output levels from IR output jacks 1 to 3 and IR output jacks 4 to 6. Note: The default setting is high output (LEVEL 4), and so when the IR emitter is affixed to a device, the output level can be so high that remote commands cannot be controlled properly. Be sure to set the IR output level according to the status of the connected device. OFF ON 1 2 3 4 ID 12 ON OFF 1 2 3 4 OUT6 OUT5 OUT4 OUT3 OUT2 OUT1 1 2 3 4 5 6 LEVEL 1 2 3 4 OUTPUT 4+5+6 SW 1 SW 2 OFF OFF OFF ON ON OFF ON ON OUTPUT 1+2+3 SW 3 SW 4 OFF OFF OFF ON ON OFF ON ON SETTING THE CHANNEL Use the CH selector knob to set to the same channel as the RC3001. ON OFF 1 2 3 4 ID 12 CH selector knob Notes: • When setting the channel with the CH selector, the available channels are CH1 to CH4 with two setting positions for each channel. CH1 CH2 CH3 CH4 • The RC3001 default channel is channel 1. • To change the channel of the remote controller, change the channel setting in the Wizz.it 3 editor. 12