Marantz SR5009 Instruction Manual in English - Page 222
Symptom, Cause / Solution, and Audyssey Dynamic
View all Marantz SR5009 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
Contents Connections Playback Settings Tips Appendix Symptom Dolby PLg mode or DTS Neo:6 mode cannot be selected. Audyssey MultEQ® XT, Audyssey Dynamic EQ® and Audyssey Dynamic Volume® cannot be selected. "M-DAX" cannot be selected. No sound is output when using ZONE2. Cause / Solution 0 It cannot be selected when "Speaker Config." - "Center" or "Surround" is set for "None". 0 Dolby PLg or DTS Neo:6 cannot be selected when using headphones. 0 These cannot be selected when you have not performed Audyssey® Setup. 0 Switch to a sound mode other than "Direct" or "Pure Direct". 0 These cannot be selected when using the headphones. 0 Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used. 0 Switch to a sound mode other than "Direct" or "Pure Direct". 0 Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections. 0 When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m. Page 189 - 178 120 - 156 120 - - Front panel Display Rear panel 222 Remote Index