Marantz SR5011 Owner s Manual In English - Page 238
Symptom, Cause / Solution
View all Marantz SR5011 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
Contents Connections Playback Settings Tips Appendix Symptom Cause / Solution DTS Neural:X mode cannot 0 DTS Neural:X cannot be selected when using the headphones. be selected. Dolby Surround mode cannot be selected. 0 Dolby Surround cannot be selected when using the headphones. Audyssey MultEQ® XT, Audyssey Dynamic EQ® and Audyssey Dynamic Volume® cannot be selected. 0 These cannot be selected when you have not performed Audyssey® Setup. 0 Switch to a sound mode other than "Direct" or "Pure Direct". 0 These cannot be selected when using the headphones. "M-DAX" cannot be selected. 0 Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used. 0 Switch to a sound mode other than "Direct" or "Pure Direct". No sound is output when using ZONE2. 0 Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections. 0 When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m. Page - - 189 127 - 164 127 - - Front panel Display Rear panel 238 Remote Index