Marantz SR5600 SR5600 User Manual - Page 12

ENGLISH OPERATION OF REMOTE CONTROL UNIT REMOTE CONTROL The distance between the transmitter of the remote control and the IR SENSOR of the SR5600 should be less than 5 meters. If the remote control is pointed in a direction other than the IR SENSOR or if there is an obstacle between them, use of the remote control may not be possible. Remote-controllable range SR5600 Approx. 5 m 60° INPUT SELECTORAV SURROUND RECEIVER SR5500 MULTI STANDBY POWER ON/OFF M. SPEAKER B PHONES SUMRROODUEND AUTO DPIRUERCET HT-EQ SSIEMTPULPE MENU ENTER DISPLAY EXIT MEMORY BAND CLEAR T-MODE DOWN VOLUME MUTE UP S-VIDEO 7.1CH INPUT VIADUEXO 1 INPUT L AUDIO R Remote control unit (RC5500SR) LOADING BATTERIES The life of the batteries used with the remote control is about 4 months with normal use. Also be sure to replace batteries earlier when you notice that they are getting weak. 1. Remove the back cover. 2. Insert the new batteries (AAA type) with correct and polarity. 3. Close the cover until it clicks. Notes: • Do not mix alkaline and manganese batteries. • Do not mix old and new batteries. CAUTIONS ON BATTERIES • Use "AAA" type batteries in this remote control unit. • If the remote control unit does not operate from close to the main unit, replace the batteries with new ones, even if less then a year has passed. • The included battery is only for verifying operation. Replace it with a new battery as soon as possible. • When inserting the batteries, be careful to do so in the proper direction, following the + and marks in the remote control unit's battery compartment. • To prevent damage or battery fluid leakage: - Do not use a new battery with an old one. - Do not use two different types of batteries. - Do not short-circuit, disassemble, heat or dispose of batteries in flames. • Remove the batteries when not planning to use the remote control unit for a long period of time. • If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. GENERAL INFORMATION OF RC5500SR TO SR5600 To control the SR5600 by your RC5500SR, you have to select the device AMP or TUNER by pressing the function selector button. Please refer below for the details in AMP and TUNER mode. AMP MODE POWER TV VCR1 DSS/VCR2 DVD TUNER CD TAPE CDR/MD AUX1 TV VOL. SLEEP AMP MUTE MAIN VOL. OSD MENU ENTER SET UP/ T.TONE PURE DIRECT AUTO 1 NIGHT CSII 4 DISPLAY MCH-ST 7 CLEAR MEMO MENU OFF DTS 2 3 EX/ES 5 VIRTUAL 6 STEREO 8 7.1CH IN 9 A/D P.SCAN/V-OFF 0 CHANNEL/SKIP BASS TREBLE TUNE/SEARCH T-MODE RDS F.DIRECT INPUT/DISC+ AUDIO SUB-T/ATT PTY CH.SEL LIP.SYNC SYSTEM REMOTE CONTROLLER RC5500SR POWER Turns the SR5600 on and off Function selector * Selects a particular source component SLEEP * Sets the sleep timer function MUTE * Decreases the sound temporarily VOL 34 * Adjusts the over all sound level MENU Enters the SETUP MENU Cursor Moves the cursor for settings in the SETUP MENU ENTER • Enters the SETUP MENU • Confirms the settings in SETUP MENU SETUP/T.TONE Enters the test tone mode for setting the Speaker Level Setup MENU OFF Exits from the SETUP MENU PURE DIRECT * Selects the Pure Direct mode NIGHT * Turns on or off the NIGHT mode DISPLAY * Change the front display mode Surround mode (1-8) Selects the surround mode 7.1CH-IN (9) Selects the 7.1CH IN A/D (0) Switches between the analog and digital inputs BASS 34 * Adjusts the tone control of low frequency sound TREBLE 34 * Adjusts the tone control of high frequency sound SUB-T/ATT Reduces the input level P.SCAN/V-OFF Turns on or off the Video output TUNER MODE CH. SEL LIP.SYNC Adjusts the input level Selects the LIP. SYNC mode * These buttons are used to control SR5600 in any function mode. POWER TV VCR1 DSS/VCR2 DVD TUNER CD TAPE CDR/MD AUX1 TV VOL. SLEEP AMP MUTE MAIN VOL. OSD MENU ENTER SET UP/ T.TONE PURE DIRECT AUTO 1 NIGHT CSII 4 DISPLAY MCH-ST 7 CLEAR MEMO MENU OFF DTS 2 3 EX/ES 5 VIRTUAL 6 STEREO 8 7.1CH IN 9 A/D P.SCAN/V-OFF 0 CHANNEL/SKIP BASS TREBLE TUNE/SEARCH T-MODE RDS F.DIRECT INPUT/DISC+ AUDIO SUB-T/ATT PTY CH.SEL LIP.SYNC SYSTEM REMOTE CONTROLLER RC5500SR TUNER 0-9 CLEAR MEMO P.SCAN/V-OFF CHANNEL/SKIP 4 / ¢ TUNE/SEARCH 5 / 6 T-MODE 1 2 F.DIRECT 2 Selects a frequency band Inputs the numeric #s Clears the inputting Enters the tuner preset memory numbers Starts preset scan • Selects a preset station Tunes a station Selects the auto stereo mode or mono mode Selects the "Frequency direct input" 9