Marantz ZR6001SP ZR6001 User Manual - Page 17
Connecting Speakers
View all Marantz ZR6001SP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
ENGLISH CONNECTING SPEAKERS PASSIVE SUBWOOFER POWER AMPLIFIER INVERT OUTPUT INPUT INPUT LEVEL BTL EXT. CONT. IN MASTER SLAVE REMOTE CONT. MIN MAX VIDEO/ SYSTEM OUT OUT IN +5~13V DC FUSE SPEAKER SYSTEM MINIMUM 4 OHMS POWERED SUBWOOFER or CENTER SURROUND BACK RIGHT LEFT ANTENNA COMPONENT VIDEO INPUT-1 Y CB/PB CR/PR INPUT-2 Y CB/PB CR/PR MONITOR OUT Y CB/PB CR/PR FM (75Ω) GND AM VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT S-VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT MULTI FIXED OUT L R IR EMITTER OUT 1 2 3 4 AC OUTLETS 120V 60Hz DIGITAL IN DIGITAL OUT 3 4 COAX. RS-232C RC-5 MULTI RC IN L SL FLASHER IN 1 2 TV DVD OPT. VCR1 DSS/VCR2 CD TAPE OUT R SR CDR/MD MULTI L SL L R IN OUT IN OUT IN OUT IN OUT OUT R SR AUDIO (AUX2) SBL SBR SBL SBR C MODEL NO. ZR6001 AC IN PRE OUT SW C R L SWITCHED UNSWITCHED 1A 120W MAX 1A 120W MAX R L R L 7.1CH IN SW FRONT CENTER SURROUND SPEAKER SYSTEMS : MINIMUM 6 OHMS SURROUND BACK M. SPEAKER B CONNECTING SPEAKER WIRE 1. Strip away approx. 3/8 inch (10 mm) of wire insulation. 2. Twist the bared wire ends tight, to prevent short circuits. 3. Loosen the knob by turning it counterclockwise. 4. Insert the bare part of the wire into the hole in side of each terminal. 5. Tighten the knob by turning it clockwise to secure the wire. RIGHT LEFT RIGHT LEFT FRONT SURROUND 1. 2. 3/8 inch (10 mm) 3. 4. 5. Caution: • Be sure to use speakers with the specified impedance as shown on the rear panel of this unit. • To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. • Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks. • Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit. Note: • Be sure to connect the positive and negative cables for the speaker properly. If they are missconnected, the signal phase will be reversed and the signal quality will be corrupted. CONNECTING A SUBWOOFER Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (power amplifier built in). If your subwoofer is a passive type (power amplifier is not built in), connect a monaural power amplifier to the PRE OUT SUBWOOFER jack and connect the subwoofer to the amplifier. 14