Marantz ZR6001SP ZR6001 User Manual - Page 20
Advanced Connecting, Connecting To The Rc-5 Marantz Products Only
View all Marantz ZR6001SP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
ENGLISH ADVANCED CONNECTING CONNECTING TO THE RC-5 (MARANTZ PRODUCTS ONLY) RL RLRL DVD AUDIO PLAYER or SACD MULTI CHANNEL ANTENNA PLAYER COMPONENT VIDEO INPUT-1 Y CB/PB CR/PR INPUT-2 Y CB/PB CR/PR MONITOR OUT Y CB/PB CR/PR FM (75Ω) GND AM VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT S-VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT RL RL RL MULTI FIXED OUT IR EMITTER OUT L RL 1 2 3 4 R CENTER AC OUTLETS 120V 60Hz DIGITAL IN DIGITAL OUT 3 4 COAX. CENTER RS-232C RC-5 MULTI RC IN L FLASHER IN FRONT SURR. SURR. SUB SL SBL C MODEL NO. ZR6001 BACK WOOFER AC IN SWITCHED UNSWITCHED 1A 120W MAX 1A 120W MAX PRE OUT POWER L 1 2 OPT. TV DVD VCR1 DSS/VCR2 CD R L FRONT SURR. SURR. SUB R BACK WOOFER IN OUT IN OUT TAPE OUT R CDR/MD MULTI L IN OUT IN OUT OUT R SR SBR SW SL SBL C 7.1CH IN SR SBR SW AMPLIFER R L Subwoofer R L R L FRONT CENTER SURROUND SPEAKER SYSTEMS : MINIMUM 6 OHMS SURROUND BACK M. SPEAKER B AUDIO (AUX2) RL RL RL LR LRLR Front Center Front Left Right Surround Left Surround Right ANTENNA COMPONENT VIDEO INPUT-1 Y CB/PB CR/PR INPUT-2 Y CB/PB CR/PR MONITOR OUT Y CB/PB CR/PR FM (75Ω) GND AM VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT S-VIDEO TV DVD VCR1 IN OUT DSS/VCR2 MONITOR IN OUT OUT MULTI FIXED OUT IR EMITTER OUT L 1 2 3 4 R AC OUTLETS 120V 60Hz DIGITAL IN DIGITAL OUT 3 4 COAX. RS-232C RC-5 MULTI RC IN L SL FLASHER IN 1 2 TV DVD OPT. VCR1 DSS/VCR2 CD TAPE OUT R CDR/MD MULTI L SR SL L R IN OUT IN OUT IN OUT IN OUT OUT R SR AUDIO (AUX2) SBL SBR SBL SBR 2 C MODEL NO. ZR6001 AC IN PRE OUT SW C R L SWITCHED UNSWITCHED 1A 120W MAX 1A 120W MAX RC OUT R L R LOPTION 7.1CH IN SW FRONT CENTER SURROUND SPEAKER SYSTEMS : MINIMUM 6 OHMS SURROUND BACK M. SPEAKER B REMOTE CONTROL IN OUT 1 CD RECORDER EXTERNAL INTERNAL REMOTE CONTROL IN OUT MD DECK EXTERNAL INTERNAL REMOTE CONTROL IN OUT CD PLAYER EXTERNAL INTERNAL CONNECTING MULTI CHANNEL AUDIO SOURCE The 7.1CH INPUT jacks are for multichannel audio source such as a SACD multichannel player, DVD audio player or external decoder. If you use these jacks, switch on the 7.1CH INPUT and set the 7.1CH INPUT level by using the SETUP MAIN MENU. See page 32. Surround Back Left Surround Back Right CONNECTING AN EXTERNAL POWER AMPLIFIER The PREOUT jacks are for connecting external power amplifiers. Be sure to connect each speaker to the corresponding external power amplifier. q You can control other Marantz products through this unit with the remote control by connecting the REMOTE CONTROL terminals on each unit. The signal transmitted from the remote control is received by the remote sensor on this unit. Then the signal is sent to the connected device through this terminal. Therefore you need to aim the remote signal only to the unit. Also, if a Marantz power amplifier (some models excluded) is connected to one of these terminals, the power amplifier's, power switch is synchronized with this unit's power switch. Set the REMOTE CONTROL SWITCH on the units, other than the main unit to EXT.(EXTERNAL) for this feature. w Whenever external infrared sensors or similar devices are connected to RC-5 IN of the ZR6001, be sure to always disable operation of the infrared sensor on the main unit by using the following procedure. 1. Hold down the MULTI button and MENU button on the front panel at the same time for five seconds. 2. The setting "IR=ENABLE" is shown on the FL DISPLAY. 3. Press the or cursor button to change this to "IR=DISABLE". 4. Press the ENTER button. Once this setting is made, the infrared sensor on the main unit is disabled. Note: • Be sure to set to "IR=ENABLE" when external infrared sensors or similar devices are not connected. Otherwise, the main unit will be unable to receive remote control commands. 5. To restore the original setting, perform steps 1 to 4 to set to "IR=ENABLE". 17