Maytag MDB4949S Owners Manual 2 - Page 6
Select a Cycle cycles vary by model, Select Options options vary by model, Follow the Progress
View all Maytag MDB4949S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
STEP 3 Select a Cycle (cycles vary by model) Efficient dishwashers run longer to save water and energy, just as driving a car slower saves gas. Cycle times may increase or decrease depending on selections. Estimated cycle times after calibration are listed in the "Cycle and Options Descriptions" chart in the following section. Select the desired cycle by pressing the CYCLES button. Each time you press the Cycles button it will advance to the next available cycle. Select Options (options vary by model) See "Cycle and Option Descriptions" charts in the following section. You can customize the cycles by pressing the options desired and pressing Start/Resume. Follow the Progress of the Dishwasher Depending on the model, progress will be displayed by a fully lit display or by an indicator light on the front panel. The full lit display will glow for Wash (A), Dry (B), Lock (C), Sanitized, or Clean. It C will also show the estimated remaining time for the cycle in hours and minutes. STEP 4 Start or Resume a Cycle Run hot water at the sink nearest your dishwasher until the water is hot. Turn off water. For front control models: ■ Push door firmly closed. The door latches automatically. Select the wash cycle and options desired and press START/RESUME or press START/RESUME to repeat the same cycle and options as in the previous wash cycle. ■ You can add an item anytime before the main wash starts. Open the door slowly and add the item. Close the door firmly. Press the START/RESUME button. The cycle resumes automatically at the point of interruption. For top control models: ■ Select the wash cycle and options desired. ■ Press the START/RESUME button once and close the door. After a brief pause, the cycle will begin. The door must be closed within 4 seconds after pushing START/RESUME or the lights will flash, and the dishwasher will not begin. Press the START/RESUME button again and shut the door within 4 seconds. You can add an item anytime before the main wash starts. Open the door slowly and add the item. Press START/RESUME then close the door within 4 seconds. When delay is selected, the fully lit display will show an "h" for hour and the number of hours to delay. The indicator light will glow blue for wash, red for dry, or green for cycle complete. AB 6