Maytag MDB7809AWB Installation Instructions - Page 14

3 Built-up Floors-Add shims as needed (410".1 cm) (52c"m) 2-3(/74c"m) Built-up floors (Kitchen floor height is higher than cabinet opening.) Example: Kitchen floor tile does not extend into cabinet opening. Add shims as needed in the area shown to bring the dishwasher up to 34" (86.4 cm) below the countertop. NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use. Move Dishwasher into Cabinet Opening WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. 1 Stand dishwasher upright Install the Door Handle (on some models) Install door handle Mounting stud Mounting stud Setscrew (inside of door handle standoff) Handle Allen wrench IMPORTANT: Do not scratch the front panel during this procedure. Remove the door handle and hardware bag containing the setscrews and Allen wrench from the cardboard box. Start setscrews in handle. Place handle on mounting studs with the setscrews facing down. Push the door handle tightly against the door. Insert the short end of the Allen wrench into the setscrews. Tighten the setscrews 1/4 turn past snug. Using two or more people, stand dishwasher upright. NOTE: Do not install kickplate until instructed. 2 Move dishwasher close to cabinet opening Drain hose Water line Cable IMPORTANT: Double-check correct placement of utilities. Grasp the sides of the dishwasher at the edges of the door panel. Tilt dishwasher backward on wheels and move dishwasher close to cabinet opening. NOTE: Do not push on the front of the panel or on the console - they may dent. Helpful Tip: Temporarily tape utilities to the floor in the locations shown to prohibit them from moving when dishwasher is moved into the cabinet opening. 14