Maytag MGDC700VJ Installation Instructions - Page 3
Warning - gas dryer model
View all Maytag MGDC700VJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Location Requirements WARNING Dryer Dimensions Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. You will need A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See "Venting Requirements." A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements." A sturdy floor to support the dryer and a total weight (dryer and load) of 200 lb (90.7 kg). The combined weight of a companion appliance should also be considered. A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet kit, Part No. 279810.) Clothes may not tumble properly and models with automatic sensor cycles may not operate correctly if dryer is not level. Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector. NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer. Installation Clearances The location must be large enough to allow the dryer door to open fully. 43 ½" (110.5 cm) 23 3/4" (60.3 cm) *29 ¼" (74.3 cm) 27" (68.6 cm) *Most installations require a minimum 5½" (14 cm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." Minimum installation spacing for recessed area or closet installation The dimensions shown following are for the minimum spacing allowed. Additional spacing should be considered for ease of installation and servicing. Additional clearances might be required for wall, door, and floor moldings. Additional spacing of 1" (2.5 cm) on all sides of the dryer is recommended to reduce noise transfer. For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. Companion appliance spacing should also be considered. 18" (45.7 cm) 14" max. (35.6 cm) 48 in. 2 (310 cm2 ) 3" (7.6 cm) 1" 27" (2.5 cm) (68.6 cm) 24 in.2 (155 cm2 ) 1" 1" 29¼" 5½" (2.5 cm) (2.5 cm)(74.3 cm)(14 cm) A B C A. Recessed area B. Side view - closet or confined area C. Closet door with vents 3" (7.6 cm) Mobile Home - Additional Installation Requirements This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280) or the Canadian Manufactured Home Standard, CAN/CSA-Z240 MH. Mobile home installations require: Metal exhaust system hardware which is available for purchase from your dealer. Mobile Home Installation Kit Part #346764. See "Tools and Parts" section for ordering information. 3