Maytag MHW5500FC Use & Care Guide - Page 24
If you experience, Possible Causes, Solution
View all Maytag MHW5500FC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help - In Canada www.maytag.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) (cont.) All detergent level status lights are lit (on some models) Detergent dispenser is not securely in place. Pull out the dispenser, fill with detergent, and slide it back in place. All detergent level status lights are lit (on some models) (cont.) Detergent Level sensor error. F# E# or F## E## code other than as described above appears in display System error code. Washer making error beeps Door has not been opened and closed for at least 3 cycles. Washer beeps when START is touched Door not closed. Clean Washer LED flashing The washer has run 30 wash cycles at end of wash cycle and is indicating a reminder to run (on some models) the Clean Washer with affresh® cycle. Touch POWER/CANCEL to reset system. If all detergent status LEDs remain lit, unplug washer for 30 seconds, then plug back in. If problem remains, remove cartridge and use single-load dispensing until problem can be resolved. Touch POWER/CANCEL once to clear the code. Then touch POWER/CANCEL again to restart washer. If code appears again, call for service. Unplug washer for 30 seconds, then plug back in. This code may occur when the washer is first turned on. Open and close the door to clear the display. Close the door completely. Run the Clean Washer with affresh® cycle. If the Clean Washer with affresh® cycle is not turned on, the LED will stop flashing at the end of a wash cycle after running 3 more regular wash cycles. After 30 more wash cycles are completed, the Clean Washer with affresh® LED will again flash at the end of a wash cycle as a reminder. 24