NEC 60XC10 42XC10 50XC10 60XC10 user's manual - Page 27

continued

Get NEC 60XC10 PDF manuals and user guides View all NEC 60XC10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

RS-232C - continued The following control sequence is used for a single monitor When using the following control commands, all of the daisy-chained monitors can be controlled at the same time from the primary monitor. However, reply and status commands will only pertain to the primary monitor, and not to the secondary monitors. 1) Interface PROTOCOL BAUD RATE DATA LENGTH PARITY BIT STOP BIT FLOW CONTROL RS-232C 9600 [bps] 8 [bits] NONE 1 [bit] NONE 2) Control command diagram The command is structured by the address code, function code, data code and end code. The length of the command is different for each function. HEX ASCII Address Code 30h 30h '0' '0' Function Code Function Function Data Code Data Data End Code 0Dh [Address code] 30h 30h (In ASCII code, '0' '0') fixed. [Function code] A code of each fixed control move. [Data code] A code of each fixed control data (number) and not always indicated. [End code] 0Dh (In ASCII code, ' ' ) fixed. To control multiple monitors that are daisychained together please use the extended control command. English-24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
English-24
RS-232C
- continued
°e following control sequence is used for a single monitor
When using the following control commands, all of the daisy-chained monitors
can be controlled at the same time from the primary monitor. However, reply and
status commands will only pertain to the primary monitor, and not to the secondary
monitors.
1) Interface
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY BIT
NONE
STOP BIT
1 [bit]
FLOW CONTROL
NONE
2) Control command diagram
°e command is structured by the address code, function code, data code and end
code. °e length of the command is different for each function.
Address Code
Function Code
Data Code
End Code
HEX
30h 30h
Function
Data
0Dh
ASCII
'0' '0'
Function
Data
[Address code]
30h 30h (In ASCII code,
'
0
'
'
0
'
) fixed.
[Function code]
A code of each fixed control move.
[Data code]
A code of each fixed control data (number) and
not always indicated.
[End code]
0Dh (In ASCII code,
'
'
) fixed.
To control multiple monitors that are daisy-
chained together please use the extended control
command.