NEC HT510 HT510_510 UM - Page 14
Part Names of the Projector
UPC - 050927248207
View all NEC HT510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1. INTRODUCTION Part Names of the Projector Controls (See page E-4) Ventilation (inlet) Speaker Remote Sensor (See page E-9) Focus ring (See page E-26) Zoom lever (See page E-25) Lens Adjustable Tilt Foot Lever (See page E-25) Lens Cap Adjustable Tilt Foot (See page E-25) SELECT ADAJ.UTO ON/STAND BY POWESRTAT LUASMP CONTROL S-VIDEO IN COMPUTER IN Cb/Pb Y AUDIO IN COMPCOr/NPEr NT IN VIDEO IN L/mono AUDIO IN R AC IN Ventilation (outlet) Terminal Panel (See page E-5) AC Input Connect the supplied power cable's two-pin plug here, and plug the other end into an active wall outlet. (See page E-20) Main Power Switch When you plug the supplied power cable into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode. (See page E-21) Lamp Cover (See page E-46) POWESRTATULASMP ON/STAND BY ADAJU. TO SOURCE SELECT LENS SHIFT UP Lamp Cover Screw (See page E-46) Lens Shift Dial (down/up) (See page E-15) Ventilation (inlet) Adjustable Rear Foot (See page E-24) Built-in Security Slot ( ) * * This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc. E-3