NEC HT510 HT510_510 UM - Page 38

3. PROJECTING AN IMAGE (BASIC OPERATION) Optimizing an RGB Image Automatically Adjusting the Image Using Auto Adjust Optimizing an RGB image automatically Press the AUTO ADJ. button to optimize an RGB image automatically. [Poor picture] Cabinet controls LAMP STATUS POWER SOURCE ON/STAND BY AUTO ADJ. SELECT Remote control OFF POWER ON COMPONENT COMPUTER VIDEO C-VIDEO COMP. S-VIDEO AUTO ADJ. AUTO [Normal picture] Press the AUTO ADJ. button to fine-tune the computer image or to remove any vertical banding that might appear and to reduce video noise, dot interference or cross talk (this is evident when part of your image appears to be shimmering). This function adjusts the clock frequencies that eliminate the horizontal banding in the image. This function also adjusts the clock phase to reduce video noise, dot interference or cross talk. (This is evident when part of your image appears to be shimmering.) This adjustment may be necessary when you connect your computer for the first time. NOTE: • Some signals may not be displayed correctly or take time. • The Auto Adjust function does not work for component and video signals. • If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually. See page E-37. Turning Up or Down Volume Sound level from the speaker can be adjusted. Cabinet controls decrease volume increase volume LAMP STATUS POWER SOURCE ON/STAND BY AUTO ADJ. SELECT increase volume decrease volume Remote control PIC-MUTE OFF TIMER MUTE FREEZE TIMER VOLUME KEY STONE HELP LIGHT NOTE: When no menus appear, the SELECT ̇ and ̈ buttons on the projector cabinet work as a volume control. E-27