Netgear GSM7328SNA 7000 Series Managed Switch Administration Guide for Softwar - Page 99
Enable OSPFv3, and assign 2.2.2.2 as the router ID., Enable routing mode on interface 1/0/13
UPC - 606449042979
View all Netgear GSM7328SNA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
ProSafe 7000 Managed Switch Release 8.0.3 2. Enable OSPFv3, and assign 1.1.1.1 to router ID. (Netgear Switch) (Config)#ipv6 router ospf (Netgear Switch) (Config-rtr)#enable (Netgear Switch) (Config-rtr)#router-id 1.1.1.1 (Netgear Switch) (Config-rtr)#exit 3. Enable routing mode on the interface 1/0/1, and assign the IP address 2000::1 to IPv6,. (Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#routing (Netgear Switch) (Interface 1/0/1)#ipv6 address 2000::1/64 (Netgear Switch) (Interface 1/0/1)#ipv6 enable 4. Enable OSPFv3 on the interface 1/0/1, and set the OSPF network mode to broadcast. (Netgear Switch) (Interface 1/0/1)#ipv6 ospf (Netgear Switch) (Interface 1/0/1)#ipv6 ospf network broadcast (Netgear Switch) #show ipv6 ospf neighbor Router ID ---------- 2.2.2.2 Priority -------- 1 Intf ID ------- 13 Interface --------- 1/0/1 State Full/BACKUP-DR DeadTime ------- 34 5. On A2, enable IPv6 unitcast routing on the switch. (Netgear Switch) (Config)#ipv6 unicast-routing 6. Enable OSPFv3, and assign 2.2.2.2 as the router ID. (Netgear Switch) (Config)#ipv6 router ospf (Netgear Switch) (Config-rtr)#enable (Netgear Switch) (Config-rtr)#router-id 2.2.2.2 (Netgear Switch) (Config-rtr)#exit 7. Enable routing mode on interface 1/0/13, and assign the IP address 2000::2 to IPv6. (Netgear Switch) (Config)#interface 1/0/13 (Netgear Switch) (Interface 1/0/13)#routing (Netgear Switch) (Interface 1/0/13)#ipv6 address 2000::2/64 (Netgear Switch) (Interface 1/0/13)#ipv6 enable Chapter 7. OSPF | 99