Nikon 2170749 Instruction Manual - Page 29

Setting/Imprinting Language/Title-continued 3 Fully depress the shutter release button to take a picture. The selected title in the selected language will be imprinted on the print. /Th N • The selected title number can be confirmed by pressing the 115111 button, and the selected language number can be confirmed by pressing them button. • Data, such as date/time or title, is magnetically recorded on the data disk of the film cartridge during film rewind. If exhausted batteries are used at low temperatures, data may not be recorded properly. To avoid this, we recommend not to rewind film at low temperatures or make sure the battery power is sufficient before film rewind. NOTE: Canceling language and title numbers The selected language and title numbers remain unless - - (no title) or another number is selected. Note that turning the power switch off or changing the batteries does not cancel the numbers. 58 Self-Timer Operation ■ You can use the self-timer when you want to be in the photograph. Use a tripod or place the camera on a stable surface before using the self-timer. 1 Press the (-) (self-timer) button and confirm that 0 appears on the LCD panel. (Or press the ca), button and rotate the Command Dial until 6 appears.) s 42 AUTO • The self-timer cannot be operated unless the camera's shutter can be released (i.e. when subject cannot be in focus with autofocus). (Be sure to check for warning indications.) • Cover the eyepiece with the supplied eyepiece cap (page 62) or your hand before pressing the shutter release button in order to prevent interference from stray light and achieve the correct exposure. • Do not stand in front of the lens when setting the self-timer in the autofocus mode. 2 Compose the picture, focus and fully depress the shutter release button. -,nntur Without built-in Speedlight - With built-in Speedlight • I • When the self-timer is activated, the shutter releases in 10 seconds. The selftimer/red-eye reduction lamp blinks for 8 sec. and then stops blinking for 2 sec. before the shutter is released (and 0 in the LCD panel blinks for 10 sec.). When Red-Eye Reduction (page 63) is set, the self-timer/red-eye reduction lamp lights at the same output level as the normal Red-Eye Reduction function before the shutter releases. • To cancel the self-timer before self-timer operation, press the CCD button again or rotate the Command Dial while pressing the OD button so 0 and disappear from the LCD panel. To cancel the self-timer during self-timer operation, turn the power switch off or press the CCE) button again. • When bulb is set, shutter speed is automatically controlled to 1/30 sec. 59