NordicTrack A.c.t. 10 Elliptical English Manual - Page 11

7. Using a small plastic bag to keep your fingers clean, apply a generous amount of the included grease to the right axle on the Upright (2). Next, identify the Right Handlebar Leg (13) and orient it as shown. See the inset drawing. While a second person holds the Right Handlebar Leg (13) near the Upright (2), tie the indicated wire tie to the Right Extension Wire (80). Then, pull the other end of the wire tie through the Right Handlebar Leg. Tip: Avoid pinching the Right Extension Wire (80). Slide the Right Handlebar Leg (13) onto the axle on the Upright (2). Attach the Right Handlebar Leg with an M10 x 20mm Screw (61) and an M10 Washer (64). Attach the Left Handlebar Leg (12) in the same way. 7 12 100 80 2 Avoid pinching the wires 2 Grease 80 13 64 61 Wire Tie 13 8. Identify the Right Pedal Arm (15), the Right Pedal (9), and the Right Pedal Insert (104), and 8 orient them as shown. Attach the Right Pedal (9) and the Right Pedal 9 15 Insert (104) to the Right Pedal Arm (15) with six M6 x 12mm Screws (78). 104 Attach the Left Pedal (not shown) and the Left Pedal Insert (not shown) to the Left Pedal Arm (not shown) in the same way. 78 11