NordicTrack A.c.t. 10 Elliptical English Manual - Page 29

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. 86 88 67 CONSOLE TROUBLESHOOTING If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 21. 7 93 If a replacement power adapter is needed, call the telephone number on the cover of this manual. IMPORTANT: To avoid damaging the console, use 53 only a manufacturer-supplied regulated power 17 adapter. HOW TO LEVEL THE ELLIPTICAL If the elliptical rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL on page 16. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. See EXPLODED DRAWING C on page 35. First, remove the Right Rail Cover (93) and the Right Rail Cover Cap (7). Then, remove all of the Screws (67, 73) from the Right Outer and Inner Shields (17, 19); there are two sizes of Screws in the Right Outer and Inner Shields—-note which size of Screw you remove from each hole. Then, gently remove the Right Outer Shield. Next, locate the Reed Switch (86). Turn the Pulley (53) until a Magnet (88) is aligned with the Reed Switch. Loosen, but do not remove, the indicated M4 x 16mm Screw (67). Slide the Reed Switch (86) slightly closer to or away from the Magnet (88), and then retighten the Screw. Then, rock the Pulley (53) forward and backward so that the Magnet passes the Reed Switch repeatedly. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the right outer and inner shields and the right rail cover and the right rail cover cap. 29