NordicTrack Elite 14.7 Elliptical English Manual - Page 31

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. To adjust the drive Replace any worn parts immediately. belt, first use a flat screwdriver to remove 56 To clean the elliptical, use a damp cloth and a small the Lower Upright amount of mild soap. IMPORTANT: To avoid damage Cover (56). to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING Next, remove the M4 If the console does not display your heart rate when x 16mm Screw (104), you hold the handgrip heart rate monitor, or if the dis- and then use a flat 104 played heart rate appears to be too high or too low, see screwdriver to remove 75 step 5 on page 22. the Shield Cover (75). If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 15. HOW TO CALIBRATE THE INCLINE OF THE RAMP If the ramp is not functioning properly, the incline of the ramp may need to be calibrated. To calibrate the incline of the ramp, see step 4 on page 27. Then, use a flat screwdriver to remove the Front Stabilizer Cover (8). 8 HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. Remove the three M4 x 16mm Screws (104) and the M4 x 16mm Machine Screw (128) from the right Disc (71). Then, gently remove the right Disc. 128 104 71 104 104 31