NordicTrack Exp2000 Treadmill English Manual - Page 20
How to Move the TREKKER, Trouble-shooting
View all NordicTrack Exp2000 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
How to Move the TREKKER Before moving the TREKKER, change the grade of the TREKKER to the lowest level and unplug the power cord. 1. Hold the handrails as shown and place one foot against the walking belt. 2. Tilt the TREKKER back until it rolls freely on the wheels. The help of a second person may be helpful when tipping the TREKKER. Carefully move the TREKKER to the desired location. Never move the TREKKER without tipping it back. To reduce the risk of injury, use extreme caution while moving the TREKKER. Do not attempt to move the TREKKER over an uneven surface. 3. Place one foot on the walking belt, and carefully lower the TREKKER until it is resting on the floor. Wheels Trouble-shooting Most problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-888-8252588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps. Important: The TREKKER is not compatible with GFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. c. Check the circuit breaker located on the TREKKER near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in. d. Check the on/off switch located on the TREKKER near the power cord. The switch must be in the on position. c Tripped Reset Tripped d On Position Reset 20