NordicTrack Vx9000 English Manual - Page 7

4. Refer to step 1. While a second person holds the 4 Uprights (95, 97), remove the two Upright Bolts (96). Slide the Uprights (95, 97) fully onto the brackets on the Frame (not shown). Be careful to avoid pinching your hands or the Wire Harness (not shown). Attach each 91 Upright with four Upright Bolts (96) as shown. Firmly tighten all eight Upright Bolts. Firmly tighten the four Handrail Bolts (99). 5. Plug the indicated end of the Power Cord (48) fully into 5 the treadmill as shown. 99 91 97 96 96 95 96 48 6. When the treadmill is in the location where it will be 6 used (see HOW TO MOVE THE TREADMILL below), make sure that both Rear Feet (5) and both front Wheels (not shown) rest firmly on the floor. If the tread- mill rocks slightly, loosen the Rear Foot Locknut (111) above the right Rear Foot. Turn the right Rear Foot clockwise or counterclockwise until the rocking motion is eliminated. Then, tighten the Rear Foot Locknut. 111 5 111 5 7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill. HOW TO MOVE THE TREADMILL Note: It may be helpful to leave the treadmill at an incline before moving the treadmill. Before moving the treadmill, make sure that the power cord is unplugged from the wall outlet. Due to the size and weight of the treadmill, moving it requires two persons. While one person lifts the indicated end, firmly hold the handrails and tip the treadmill forward until it rolls on the front wheels. Carefully move the treadmill to the desired location and then lower it. CAUTION: To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over uneven surfaces. Lift Here Handrails Wheels 7