Olympus D-380 D-380 Reference Manual (4.1MB) - Page 34
Using the flash, Open the lens barrier., Press, while the current flash, setting is displayed.
UPC - 050332137578
View all Olympus D-380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Using the flash In the auto-flash mode (factory default setting), the flash is designed to fire automatically when shooting under low light or against strong backlight, but you can change the flash mode to suit different shooting situations. Select the flash mode best suited to the light conditions and the effect you want to achieve. 1 Open the lens barrier. The camera turns on in the shooting mode. 2 Press . The current flash setting is displayed. AUtO Shooting basics 3 Press while the current flash setting is displayed. Each time you press , the flash mode is switched in the following sequence: AUTO - - - - - . 4 Take the picture. • The flash working range is approximately 2.5 m/8.2 ft. • The camera returns to the auto-flash mode (factory default setting) when the lens barrier is closed. "Saving the settings (All Reset)" ( p.78) • While the green lamp is blinking, the flash is charging and shooting is not possible. Wait until the lamp goes off, then retry shooting. • If you use the flash when shooting at a close distance, shadows may be conspicuous and the correct exposure may not be achieved. • In sequential shooting, panorama or movie mode, the flash is disabled. 33