Olympus D545 D-545 Zoom Advanced Manual (English) - Page 110
Set [ALL RESET] to [OFF]., See Error codes.
UPC - 050332153394
View all Olympus D545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Troubleshooting Possible cause Corrective action Ref. page There is a problem with See "Error codes". the card. P. 107 The monitor is hard to see. There is condensation* inside the camera. The brightness of the monitor is not adjusted properly. Turn the camera off and wait until it dries before turning it on again. Use [s] to adjust monitor brightness. - P. 74 The monitor is exposed Block the sunlight with your hand while taking - to direct sunlight. pictures. Vertical lines appear on Aiming the camera at a bright subject in - the monitor screen sunlight may cause vertical lines to appear during shooting. on the screen. This is not a malfunction. The date recorded with the image data is wrong. The date/time is not set. Set the date/time. The clock adjustment is not factory-preset. P. 75 The camera has been left without batteries. If the camera is left without batteries for 3 days, the date/time setting is canceled. Set the date/time again. P. 75 The settings are returned to the factory default settings when the camera is turned off. [ALL RESET] is set to [ON]. Set [ALL RESET] to [OFF]. P. 69 The picture is out of focus. The subject was too close. Move further away from the subject. To take pictures closer than 20 cm (7.9") with the zoom in the maximum wide position, use the super macro mode. P. 40 Auto focus is not possible. Use the focus lock to focus on your subject. P. 24 There is condensation* Turn the camera off and wait until it dries - 9 on the lens. before turning it on again. Appendix 110