Olympus E-30 E-30 Instruction Manual (English) - Page 63
Checking the image stabilizer effect with live view, IMAGE STABILIZER] - e 30 camera
UPC - 050332166967
View all Olympus E-30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Setting the focal length By setting in advance the focal length of the lens, you can use the image stabilizer function also with lenses other than Four Thirds system lenses. This setting is deactivated when a Four Thirds system lens is attached. 1 Press the F button when the image stabilizer is turned on. 2 Use the dial or ac to set the focal length and press i. IMAGE STABILIZER OFF I.S. 1 I.S. 2 I.S. 3 FOCAL LENGTH 50 mm SET Focal lengths that can be set (based on a 35-mm camera) 8 mm 10 mm 12 mm 16 mm 18 mm 21 mm 24 mm 28 mm 30 mm 35 mm 40 mm 48 mm 50 mm 55 mm 65 mm 70 mm 75 mm 80 mm 85 mm 90 mm 100 mm 105 mm 120 mm 135 mm 150 mm 180 mm 200 mm 210 mm 250 mm 300 mm 3 350 mm 400 mm 500 mm 600 mm 800 mm 1000 mm • If the focal length of the lens you are using is not listed, select the closest value. Focusing and shooting functions Checking the image stabilizer effect with live view You can hold down the o button during live view to see the effect of the image stabilizer on the monitor. While in that position, you can press the shutter button fully to take a picture. • When [IMAGE STABILIZER] is set to [OFF], pressing and holding the o button activates the image stabilizer ([I.S. 1]). • Either releasing the o button or holding down the o button for several seconds turns off the image stabilizer. 250 F5.6 IS 1 LN 38 Green light : Image stabilizer active Red blinking : Image stabilizer failure x Notes • The image stabilizer cannot correct excessive camera shake or camera shake that occurs when the shutter speed is set to the slowest speed. In these cases, it is recommended that you use a tripod. • When using a tripod, set [IMAGE STABILIZER] to [OFF]. • When using a lens with an image stabilization function, turn off the image stabilization function of either the lens or the camera. • If [IMAGE STABILIZER] is set to [I.S.1], [I.S.2] or [I.S.3] and you turn off the camera, the camera will vibrate. This is due to the camera initializing the image stabilizer mechanism. Without this initialization, the image stabilizer may not be able to achieve the proper effect. • If the image stabilizer icon blinks in red on the monitor, it indicates a failure of the image stabilizer function. If you take a picture as is, the composition may be off. Consult your Olympus Authorized Service Center. 63 EN