Olympus FE 210 FE-210 Advanced Manual (English) - Page 45
Getting to know your camera better, Shooting tips and information - putting pictures onto computer
UPC - 050332159914
View all Olympus FE 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Getting to know your camera better Getting to know your camera better Shooting tips and information Tips before you start taking pictures The camera does not turn on even when a battery is loaded The battery is inserted incorrectly • Remove the batteries and insert them correctly. There is not enough power left in the battery • Insert new batteries. Or, charge it when using the rechargeable battery. The battery is temporarily unable to function because of the cold • Battery performance declines in low temperatures, and the charge may not be sufficient to turn on the camera. Remove the battery and warm it by putting it in your pocket for a while. No picture is taken when the shutter button is pressed The camera is in sleep mode • To save battery power, the camera automatically goes into sleep mode and the monitor turns off if there is no operation when the camera is turned on (when the lens is extended and the monitor is on). No picture is taken even if the shutter button is fully pressed in this mode. Operate the zoom lever or other buttons to restore the camera from sleep mode before taking a picture. If the camera is left for 12 minutes, it automatically turns off (the lens retracts and the monitor turns off). When the power is turned on in the playback mode, the camera does not enter the sleep mode but just turns off automatically after about three minutes. Press o to turn the camera on. The mode dial is in the position of g • No pictures can be taken when the guide is being displayed. Take pictures after setting target terms by following the shooting guide or set it to the setting other than g in shooting mode. The flash is charging • Wait until the # (flash charge) mark stops blinking before pushing the shutter button again. The date and time have not been set The camera has been used in the same conditions from the time of purchase • No date and time have been set in the camera at the time of purchase. Set the date and time before using the camera. g "Set date and time" (P. 6), "X Setting the date and time" (P. 26) The battery has been pulled out of the camera • The date and time settings will be returned to the factory default settings if the camera is left without batteries for approximately 1 day. The settings will be canceled more quickly if the batteries were only loaded in the camera for a short time before being removed. Before taking important pictures, check that the date and time settings are correct. EN 45