Onkyo 8222 Owner Manual - Page 27

Listening to the Radio-Continued I Tuning into Stations by Frequency You can tune into AM and FM stations directly by entering the appropriate frequency. 1 Receiver Press the [DIRECT TUNING] button. Remote controller (Actual display depends on country.) 2 Receiver Remote controller Within 8 seconds, use the number buttons to enter the frequency of the radio station. For example, to tune to 87.5 (FM), press 8, 7, 5. To cancel the number entry, press the [CLR] button on the remote controller. 4 Receiver Press the [MEMORY] button again to store the station or channel. The station or channel is stored and the preset number stops flashing. Repeat this procedure for all of your favorite AM/FM radio stations and XM channels. I Selecting Presets 1 Receiver Remote controller To select a preset, use the number buttons on the receiver, or the remote controller's PRESET [ ]/[ ] buttons. For the TX-8522 other than North American model, the PRESET [ ]/[ ] buttons on the receiver also can be used to select a preset. Presetting AM/FM Stations Number buttons MEMORY TUNING MODE PRESET / I Deleting Presets 1 Select the preset that you want to delete. See the previous section. 2 Receiver While holding down the [MEMORY] button, press the [TUNING MODE] button. The preset is deleted and its number disappears from the display. You can store a combination of up to 40 of your favorite AM/FM radio stations as presets. 1 Tune into the AM/FM station that you want to store as a preset. 2 Receiver Press the [MEMORY] button. The MEMORY indicator appears and the preset number flashes. The North American model changes FM frequency in 0.2 MHz steps, 10 kHz steps for AM. For other models it's 0.05 MHz steps for FM and 9 kHz (or 10 kHz) steps for AM. When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator also appears. TUNED AUTO 3 Receiver While the MEMORY indicator is displayed (about 8 seconds), use the number buttons on the receiver to select a preset from 1 through 40. FM STEREO Tuning into Weak FM Stereo Stations If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono. 27