Onkyo A-9010 Instruction Manual - Page 11

Operations (UK models) Í ON/STANDBY button Remote control sensor Volume control Input source LEDs MUTING LED ASB (Auto Standby) LED INPUT selector BASS control TREBLE control BALANCE control DIRECT LED DIRECT button LOUDNESS LED LOUDNESS button LINE 5 jack: Connects to reproducing equipment such as portable audio player via stereo mini-plug (ø 3.5 mm). PHONES jack Turning on the unit 1. Press the Í ON/STANDBY button. The input source LED blinks, then lights up after a short time. To return to standby mode: This unit will go into standby mode by pressing the Í ON/STANDBY button again, then the input source LED will go off. 0 The power of Onkyo equipment connected via RI will be automatically turned off when the power is turned to standby. The Auto Standby can be set on this unit. For detail, refer to "Setting the Auto Standby function" (> 12). Selecting the input source 1. Switch the input source by turning the INPUT selector. Input from following can be selected. (North American and Continental European models) D 1, D 2, LINE 1, LINE 2, LINE 3, LINE 4, LINE 5, PHONO (UK models) LINE 1, LINE 2, LINE 3, LINE 4, LINE 5, PHONO The input source LED corresponding to the selected input lights up. 0 If there is no input signal when D 1 or D 2 is selected, the LED for that source will blink. Adjusting the volume 1. Adjust the volume by slowly turning the volume control. En-11