Onkyo HT-R520 Owner Manual - Page 37

)53@&OCPPL 1BHF  .POEBZ .BSDI 1. Common Functions-Continued Muting the HT-R520 With this function you can temporarily mute the output of the HT-R520. MUTING Press the remote controller's [MUTING] button. The output is muted and the MUTING indicator flashes on the display, as shown. To unmute the HT-R520, press the remote controller's [MUTING] button again, or adjust the volume. The output is unmuted and the MUTING indicator goes off. Muting is cancelled when the HT-R520 is set to Standby. Using the Sleep Timer With the sleep timer you can set the HT-R520 so that it automatically turns off after a set period. Press the [SLEEP] button repeat- SLEEP edly to select the required sleep time. You can set the sleep time from 90 to 10 minutes in 10 minute steps. The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears. SLEEP indicator Adjusting Speaker Levels Temporarily You can adjust individual speaker levels while listening to an input source. These temporary adjustments are cancelled when the HT-R520 is set to Standby. 1 CH SEL LEVEL- LEVEL+ Use the remote controller's [CH SEL] button to select each speaker, and use the [LEVEL-] and [LEVEL+] buttons to adjust the volume. Speakers are selected in the following order: Left → Center → Right → Surr Right → Surr Back → Surr Left → Subwoofer. You can adjust the volume of each speaker from -12 dB to +12 dB (-15 dB to +12 dB for the subwoofer). The name of the currently selected speaker and its volume appear on the display, as shown. Notes: • You cannot use this function while the HT-R520 is muted. • Speakers that are set to No or None in the Speaker Configuration cannot be adjusted. To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears. To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you'll shorten the sleep time by 10 minutes. Using Headphones You can connect a pair of stereo headphones (1/4-inch phone plug) to the HT-R520's PHONES jack for private listening, as shown. STANDBY/ON POWER ON OFF A SPEAKERS B PHONES Notes: • Always turn down the volume before connecting your headphones. • Speaker sets A and B are turned off while the head- phones plug is inserted in the PHONES jack. • When you connect a pair of headphones, the listening mode is set to Stereo, unless it's already set to Stereo or Direct. When you disconnect the headphones, the previous listening mode is selected. • When the multichannel DVD input is selected, only the front left and front right sounds can be heard in the headphones. 37