Onkyo HT-R520 Owner Manual - Page 44
Advanced Function - amp no sound
View all Onkyo HT-R520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
)53@&OCPPL 1BHF .POEBZ .BSDI 1. Advanced Function Using the Audio Adjust Functions These functions only work with speaker set A. Audio Adjust provides various functions for adjusting the sound. TONE DVD _ + REMOTE MODE CD MD TUNER/ TAPE AMP CDR ENTER TV VCR CABLE SAT DIMMER TV INPUT + CH DISC - PREV CH DISPLAY TOP MENU MENU ENTER EXIT RETURN GUIDE SETUP SLEEP VOL MUTING SETUP L NIGHT REC SP A SP B RANDOM AUDIO SUBTITLE ANGLE LAST M SURR ALL ST STEREO REPEAT A-B SEARCH MEMORY DIRECT DSP DSP TEST TONE CH SEL OPEN/CLOSE VIDEO OFF OR-EQ LEVEL L NIGHT LEVEL+ CINE FLTR RC-570M CINE FLTR 1 Press the [SETUP] button. 2 ENTER Use the Up and Down [ ]/[ ] buttons to select "4. Audio Adjust," and then press the [ENTER] button. ENTER 3 ENTER Use the Left and Right [ ]/[ ] buttons to specify the settings. 4 ENTER Press the Down [ ] button to select the next setting. 5 6 44 Repeat steps 3 and 4 to complete all settings. Press the [SETUP] button. Setup closes. The Audio Adjust functions are explained below. ■ Double Bass The Double Bass function boosts the bass by feeding bass sounds from the front left and right channels to the subwoofer. To use this function, in the Speaker Configuration, the Subwoofer setting must be set to Yes and the Front setting must be set to Large (see page 48). The Double Bass function works well with mono and 2channel sources, including 96 kHz PCM. On: Double Bass function on. Off: Double Bass function off. ■ Late Night (Dolby Digital only) With this function you can reduce the dynamic range of Dolby Digital material so that you can still hear quiet parts even when listening at low volume levels-ideal for watching movies late at night when you don't want to disturb anyone. Off: Late Night function off. Low: Small reduction in dynamic range. High: Big reduction in dynamic range. Note that the effect of the Late Night function depends on the Dolby Digital material that you are playing, and with some material there will be little or no effect. This function is turned off when the HT-R520 is set to Standby. Tip: You can also set this function by using the remote controller's [L NIGHT] button. ■ CinemaFILTER With this function, you can soften the harshness, or brightness sometimes experienced with movie soundtracks, which are typically mixed for reproduction in a movie theater. You can set the CinemaFILTER function to On or Off. The CinemaFILTER function can be used with the following listening modes: Dolby Digital, Dolby Digital EX, Dolby Pro Logic II Movie, Dolby Pro Logic IIx Movie, DTS, DTS-ES, DTS Neo:6 Cinema, DTS 96/24, DTS+Neo:6, and DTS+Dolby EX. Tip: You can also set this function by using the remote controller's [CINE FLTR] button. Adjusting the DTS Neo:6 Music Mode ■ Center Image DTS Neo:6 derives a center-channel signal from stereo material, either analog or digital. In Music mode, the center speaker is intended to augment the left and right speakers, allowing them to faithfully reproduce the original stereo mix. For this reason, the center channel sound is not fully subtracted from the left and right channels. With this function, you can adjust the amount of subtraction depending on your room layout and personal preference.