Onkyo HT-R520 Owner Manual - Page 47

)53@&OCPPL 1BHF  .POEBZ .BSDI 1. Advanced Setup-Continued Speaker Levels 3 With this function you can adjust the volume of each speaker so that all speakers can be heard equally at the listening position. Speaker levels cannot be set while the HT-R520 is muted. Turn up the volume so that you can hear the test tone sufficiently. While each speaker outputs the test tone, its name appears on the display, as shown. ENTER ON STANDBY I T V INPUT V1 V2 V3 1 2 3 + DVD MULTI CH 4 5 6 TV CH - CD 7 +10 --/--TONE TAPE 8 0 TUNER 9 T V VOL CLEAR TUNER/ TAPE _ + AMP REMOTE MODE DVD CD MD CDR TV VCR CABLE SAT DIMMER TV INPUT + CH DISC TOP MENU MENU ENTER SLEEP VOL - PREV CH DISPLAY EXIT RETURN GUIDE SETUP MUTING REC SP A SP B RANDOM AUDIO SUBTITLE ANGLE LAST M SURR ALL ST STEREO REPEAT A-B SEARCH MEMORY DIRECT DSP DSP TEST TONE CH SEL OPEN/CLOSE VIDEO OFF OR-EQ LEVEL L NIGHT LEVEL+ CINE FLTR RC-570M SETUP 1 AMP Press the [AMP] button followed by the [SETUP] button on the remote controller. 4 ENTER ENTER Use the Left and Right [ ]/[ ] buttons to adjust the speaker level, and use the Down [ ] button to select the next speaker. The level can be adjusted from -12 to +12 dB in 1 dB steps (-15 to +12 dB for the subwoofer). 5 Repeat step 4 so that the level of the test tone from each speaker is the same. Speakers that you set to No or None in the Speaker Configuration (page 48) do not output the test tone. 6 Press the [SETUP] button. Setup closes. Don't forget to turn down the volume if you turned it up while setting the levels. 2 ENTER ENTER Use the Up and Down [ ]/[ ] buttons to select "3. Level Cal," and then press the [ENTER] button. A pink noise test tone is output by the front left speaker. Notes: • This procedure can also be performed by using the remote controller. First press the [TEST TONE] button to output the test tone. Use the [LEVEL-] and [LEVEL+] buttons to adjust the levels, and use the [CH SEL] button to select the speakers. 47