Onkyo HT-RC270 Owner Manual - Page 70
Controlling Zone 2 with the Remote, Controller, Adjusting the Volume for Zone 2, Muting Zone 2
View all Onkyo HT-RC270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Controlling Zone 2 with the Remote Controller STANDBY ON INPUT SELECTOR ZONE2 Note • To control Zone 2, you must press the remote controller's ZONE2 first. • ZONE2 turns red while Zone 2 is on. 1 Press ZONE2, then point the remote controller at the AV receiver and press ON. 2 To select an input source for Zone 2, press ZONE2, followed by INPUT SELECTOR. To select AM or FM, press TUNER input selector and ZONE2 repeatedly. 3 To turn off Zone 2, press ZONE2, followed by STANDBY. Note • Only analog input sources are output by the ZONE 2 LINE OUT and FRONT WIDE/ZONE 2 L/R terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it's connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that station will also be used in Zone 2. • When you connect Zone 2 speakers directly to the AV receiver, listening modes that require surround back speakers or front high speakers or front wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz Height, and Audyssey DSX™ are unavailable. • When the input selector of Zone 2 is selected, power consumption on standby mode slightly increases. • While Zone 2 is on, V functions will not work. Adjusting the Volume for Zone 2 ■ Operating with the remote controller 1 Press ZONE2. 2 Use VOL R/X to adjust the volume. ■ Operating on the AV receiver 1 Press ZONE 2 (the ZONE 2 indicator and Zone 2 selector on the display flashes). 2 Use -/+ within 8 seconds to adjust the volume. If your Zone 2 speakers are connected to a receiver or integrated amp in Zone 2, use its volume control to adjust the volume. Muting Zone 2 ■ Operating with the remote controller Press ZONE2 followed by MUTING. Tip • To unmute, press ZONE2 followed by MUTING again. En 70