Onkyo TX-8250 User Manual English etc - Page 20

> Before Start > Part Names > Install > Initial Setup > Playback Supplementary information | Advanced Setup | Others USB Storage Device 1 2 3 4 USB Front Basic Operations remote controller to select the folder and You can play music files stored on a USB storage device. music file, and then press ENTER to start playback. 0 To return to the previous display, press Perform the following procedure when the unit is on. 1. Plug your USB storage device with the music files into the USB port either on the front panel or rear panel of this unit. 2. Press NET (a) on the remote controller. RETURN (c). 0 The USB port of this unit conforms with the USB 2.0 standard. The transfer speed may be insufficient for some content you play, which may cause some interruption in sound. 3. Press the Up/Down cursors (b) on the b remote controller, select "USB Front" or "USB Rear" on the display, and then press ENTER (b). 0 If the "USB" indicator flashes on the display, check whether the USB storage device is plugged in properly. 0 Do not unplug the USB storage device while "Connecting..." is on the display. This may cause data corruption or malfunction. 4. Press ENTER on the remote controller after reading is complete. 5. Press the Up/Down cursors on the 20 Supported Audio Formats This unit supports the following music file formats. Note that sound files that are a protected by copyright cannot be played on this unit. MP3 (.mp3/.MP3): 0 Supported formats: MPEG-1/MPEG-2 Audio Layer 3 0 Supported sampling rates: 44.1 kHz, 48 kHz 0 Supported bitrates: Between 8 kbps and 320 kbps and VBR c WMA (.wma/.WMA): 0 Supported sampling rates: 44.1 kHz and 48 kHz 0 Supported bitrates: Between 5 kbps and 320 kbps and VBR 0 WMA Pro/Voice/WMA Lossless formats are not supported WAV (.wav/.WAV): WAV files include uncompressed PCM digital audio.