Onkyo TX-RZ820 Basic/Advanced Manual English - Page 14
Step2: Connect the Speakers
View all Onkyo TX-RZ820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
> Before Start > Part Names > Install > Initial Setup > Playback > Advanced Manual Troubleshooting | Supplementary Information, etc. Step2: Connect the Speakers 1/2˝ (12 mm) b Standard Connections (Pages 8 to 11) Connect 12345678 for a 7.1 channel system. Connect 1234569: for a 5.1.2 channel system. Up to two powered subwoofers can be connected. The same signal is output from each of the SUBWOOFER PRE OUT jacks. 0 You can also connect both 78 and 9:. However, you can only output audio from one of these at a time. When both are connected, you can switch which speakers to prioritize. Press Q on the remote control (P6) and use "Other" - "Speaker Layout" to switch between surround back speakers and height speakers. Setup 0 Settings for the speaker configuration you have connected need to be made in "1. AccuEQ Room Calibration" in Initial Setup (P24). 0 If any of the connected speakers have an impedance of 4 Ω or more to less than 6 Ω, after completing Initial Setup, you need to make some settings in the Setup menu. Press on the remote controller, select "2. Speaker" - "Configuration" and set "Speaker Impedance" to "4ohms". a a Speaker cable, b Subwoofer cable 14 Make sure the exposed wires of the speakers do not stick out of the speaker terminals when connecting. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated.